This article will assist with updating the firmware on your Mimaki CG-SRIII Cutter.
-
Install the Mimaki update software from the installation disc you receive with the cutter. After installation, it will prompt you to reboot the computer.
-
After rebooting the computer, turn on the cutter while holding down the “FUNC3” key. The cutter will then display “F/W UPDATE READY”.
-
Run the Mimaki update service software. This software will automatically detect the cutter and the version of firmware it currently has as well as check Mimaki’s servers for any update.
-
If there is an update, the update service software will download it and then flash the new firmware to the cutter. This process typically takes around 5-6 minutes and does not require and interaction on the customer or techs part.
- After the firmware update, the cutter will either reboot itself automatically or prompt you to power cycle it.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article